pjnewberry 0 Posted May 3, 2017 Share Posted May 3, 2017 I'm using a switch to switch my monitor between my two systems. Since both my computers are using the same monitor will that effect Synergy from installing properly Link to post Share on other sites
Solution Paul Suarez 107 Posted May 3, 2017 Solution Share Posted May 3, 2017 Hi pjnewberry! That won't affect the installation and the setup of Synergy. Link to post Share on other sites
pjnewberry 0 Posted May 3, 2017 Author Share Posted May 3, 2017 OK..that's very good news. After I read your response I was preparing to ask back "then why doesn't it switch back and forth". Well, you can guess what happened..I went to the client and it was working. It had not been working but after you answered the question, it started working...your magical. Actually I think I was just being too impatient. Once I switched back to the client and just sat there a minute trying to figure out what to write back, it started working properly. Thank you for your time...much appreciated. PJ Link to post Share on other sites
Paul Suarez 107 Posted May 3, 2017 Share Posted May 3, 2017 51 minutes ago, pjnewberry said: OK..that's very good news. After I read your response I was preparing to ask back "then why doesn't it switch back and forth". Well, you can guess what happened..I went to the client and it was working. It had not been working but after you answered the question, it started working...your magical. Actually I think I was just being too impatient. Once I switched back to the client and just sat there a minute trying to figure out what to write back, it started working properly. Thank you for your time...much appreciated. PJ You're most welcome PJ. Have a geat day! :-) Link to post Share on other sites
Recommended Posts